Schroth-racing QuickFit And QuickFit Pro BMW E82 / E92 / E92 LCI Manuel d'utilisateur télécharger pdf (Page 6)

 Bend the SCHROTH bracket as shown in the pictures

below and place the SCHROTH bracket just under

the bolt head.

 Reinstall the bolt.

 Before tightening the bolt, align the SCHROTH

connector so that the webbing is pulling in the same

direction that the belt will pass over your lap when

connected.

 Torque the bolt to 30 ft.lbs.

 Trim the plastic torx bolt cover so that it can fit back in

place over the Schroth bolt in bracket. See picture

below.

4 Installation of inside lap belt and tail strap

connectors

Simply plug the SCHROTH BMW “male” buckles (both front

and rear) into the factory provided female receptacle.

5 Installation of SCHROTH rear outside tail strap

buckles – Left & Right (Driver and Passenger) belts.

 Remove the four plastic covers that hide the child

seat mounting points. Lift up each cover at the front

edge – pull up and out towards the front of the

vehicle.

 Unclip the front edge of the seat bottom cushion by

lifting the front edge directly upwards.

(Photo of the E82)

(Photo of the E92)

 Holding up the forward edge of the cushion while

pressing down on the back center rearmost portion of

the cushion just behind the seat belt receptacles.

(See picture above).

 Lift out the cushion while maintaining pressure on the

rear to clear the retaining clip on the back of the seat

cushion.

 Locate and remove the outermost BMW lap belt

anchor bolts at the outside corners just below the rear

seatback bolsters.

(Photo of the E82)

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Schroth-racing QuickFit And QuickFit Pro BMW E82 / E92 / E92 LCI Manuel d'utilisateur Page 6