Schroth-racing QuickFit And QuickFit Pro Subaru WRX/STi (2002-200 Manuel d'utilisateur télécharger pdf (Page 8)

The following pictures show the correct

installation and use of SCHROTH asm

harnessbelts:

2 Routing of the shoulder belts

It is important to be sure to route the

SCHROTH shoulder belts between the two

posts of the headrest as pictured to the right.

i. 3 QuickFit

– Clip-In/Clip-Out

attachment points

ii. Front Inside Lap Belt Mount Points

iii. Clip the SCHROTH Lap Belt harness end

with the STi male latch into the factory

female receptacle as pictured above left.

iv.

v. Front Outside Lap Belt Mounting Points

vi. Plug in the SCHROTH female receptacle

on the outer end of the lap belt to the male

end of the connecting strap that you bolted

to the factory mounting point as pictured

above right.

vii. Inside Rear Tail Strap Mount Points

viii. Clip the SCHROTH Tail Strap end with the

STi male latch into the factory female

receptacle as pictured above left.

ix.

x. Outside Rear Tail Strap Mount Points

Plug the outside (far right or far left) tail strap with the of the

SCHROTH belt with SCHROTH male buckle into the

SCHROTH “separation buckle” that you bolted into chassis.

3 Adjustment of the seating position

Choose your most comfortable seating position for safe driving.

Driving and Safety Instructors recommend:

"Select your seating position in the vehicle so that you can fully

grip the upper edge of the steering wheel with your elbow still

slightly bent and without moving your upper body from the

seatback. With the clutch (automatic transmission-brake) fully

depressed your knee should still be slightly bent."

Remember: A "laid back" seating position might look 'cool', but

does not contribute in any way to better or safer handling of

your vehicle! No racing or rally driver is "laid back" in his

vehicle!

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Schroth-racing QuickFit And QuickFit Pro Subaru WRX/STi (2002-200 Manuel d'utilisateur Page 8