INSTALLATION INSTRUCTIONS
1 General Instructions
Always leave original equipment seat belts in place and
available for use.
We strongly recommend that you leave in place all BMW
factory provided 3-point restraint systems originally supplied for
the front and rear seating positions of your vehicle when you
install the SCHROTH asm harnessbelt. Removal of original
equipment restraint systems may also violate applicable State
or Federal law.
To carry rear seat passengers, you must use your standard 3-
point factory provided front seat belts. To use the factory
installed seat belts after a SCHROTH BMW Rallye 4 belt has
been installed you must first release (un-clip) all four points of
the SCHROTH belt and remove it.
Leaving original equipment restraint systems in place and fully
functional will enable you to choose either the SCHROTH
Rallye 4 OR the vehicle’s standard seat belts when it is
necessary to transport passengers in any of the rear seats or
when either harness belt is not suited for use by the driver or
front seat passenger.
On 2-door vehicles the folding front seat backrest will be
restricted in their range of motion. Evacuation or rescue of
rear seat passengers can be restricted or even impossible
after an accident and severe injuries or death may occur.
Separate SCHROTH asm harnessbelts are supplied for the
left and right sides. The black “asm cartridge” must be on
the inboard shoulder strap when system is installed (see
illustration). Never install a belt on wrong side of vehicle.
System will not function properly in an accident and
serious injury or death may occur.
Use of improper attachment points will impair system
performance.
Weak tail strap anchor points will not withstand the forces
in an accident and increase the risk of personal injury.
Never attach the tail strap to anchorages intended for the
tether straps of child seats that are found on the filler
panels behind the rear seats of some passenger cars or the
luggage area of some hatchbacks or station wagons.
These anchor points are not strong enough to withstand
the forces of an accident and are not intended for adult
be s.
lt
Harness belt systems may only be installed at suitable
anchor points for seat belt systems as originally installed
by the vehicle manufacturer.
For suitable anchor points for make, model and model
year of your vehicle, see Certified Vehicle List (Vehicle
Reference List). If in doubt, ask your dealer to show you
where these anchor points are located.
These figures show the general location and suitability of seat
belt anchor points installed as standard equipment in specific
BMW E36, E46, E39, and MINI model passenger cars.
(The E39/E46 Diagram also applies to the BMW MINI)
▀ Green Squares represent points where SCHROTH provided
male connecting tail straps are to be installed at factory
mounting points along with factory provided harnessbelts.
● Red Circles represent points where the SCHROTH BMW
Rallye 4 belts are designed to plug into BMW factory provided
seatbelt female receptacles.
5
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels